Do you have the same question? Follow this Question
Jan 06, 2021 - 07:52 AM
We’ve provided several answers to questions related to Hulk Bender Rolls, 1-3/4 inch OD , see some other helpful Q&A related to this product.
Question: Will this work with harbor freight roll bender P/N 71119
Answer: Unfortunately, these dies are too wide to work in the new Harbor Freight Roll Bender PN 71119. They do work with the older, discontinued PN 99736.
Question: Says this works with a additional drive axles what does that mean and what part is that
Answer: See the Accessories tab for the upgraded Drive Axle for Harbor Freight Rollers.
Question: Is 1-1/4" diameter .120 wall 304 round tubing too heavy for the delrin to handle? CLR of the bend is ~48''
Answer: It will work but will require you to take your time, make more passes, and be careful with the pressure you put down on the bending roll.
Question: I see a review that says this product doesn’t fit the harbor freight roller. Has this been addressed?
Answer: It does fit with the addition of the Swag Drive Axle which can be found under the Accessories tab.
Question: Does it come with bearings in the non drive rollers?
Answer: Bearings are not included with the rolls. They come with the machine and are typically switched out with all the rolls.
Question: Does it come with bearings
Answer: Bearings are not included with the roll sets. They are meant to change out with the axles and spacers.
View all Hulk Bender Rolls, Hand Rail Cap Questions & Answers
