Will this bolt onto a Black and Decker 8" Drill Press 9400 type 4 series?
Center-It Drill Jig
Does it Fit?
Status:
Open Jan 10, 2022 - 09:09 AM
1answer
Answer
Jan 10, 2022 - 09:09 AM
The mounting slots are 3-5/8 inches on center along the side of the jig and range from 2.6 - 3.9 inches across. There are many ways to adapt this to nearly and drill press but if your drill press has an X slot pattern it should bolt up just fine.
View More Product Details
Center-It Drill Jig
This jig will assist in drilling holes in round stock, tubing, and pipe. It is specifically designed for use in a drill press. The V-block bolts to the table and the angled flats hold the material firmly in place so holes can be drilled without center-punching or clamping. Simply center the jig to t...
See More
View all Center-It Drill Jig Questions & Answers
