Answer
Sep 13, 2022 - 09:02 AM
The holes would line up but you would need 5/8 attaching hardware to mount it as the 16mm hardware would be slightly too large.
will this fit on a seigmand imperial table ? these have 2" spacing and 16mm holes which are slightly over 5/8" BuildPro Tube and Pipe Notcher
Status:
Open Sep 13, 2022 - 09:02 AM
Do you have the same question? Follow this Question
1answer
View More Product Details
BuildPro Tube and Pipe Notcher
This notcher is ideal for attaching to a Buildpro table, Rhino cart, or any fixture table using 5/8 holes with 2 inch center to center spacing. The 1 inch diameter shaft is supported by needle bearings and can adjust up to 50 degrees for angled notches. An included threaded adjuster makes dialing in...
See More
View Details
