Installation?
Upper Die Clip Spring for ProLine Hammers, 10 pack
This feels like a dumb question, but I can’t see how to install one of these in the air motor. At least not without a lot of contortions and unnatural acts with pliers and screw drivers. Any pointers ?
Status:
Open Apr 29, 2024 - 04:30 PM
1answer
Answer
Apr 29, 2024 - 04:30 PM
Not a dumb question! The way we do it is to pre-twist the clip slightly and then start by pushing one end of the clip all the way into the groove. You can then work around the clip with a small screwdriver and push it down all the way around. Depending on which model hammer you have it may be easiest to remove the motor and have it upside down on the bench.
View More Product Details
View all Upper Die Clip Spring for ProLine Hammers, 10 pack Questions & Answers
