How do you use these past one full extension of the hydraulic cylinder? That only gets you to about 30 degrees Pro-Tools 105 Bender Die, 3/4 inch OD x 2 inch CLR, 180 degrees

Question

How do you use these past one full extension of the hydraulic cylinder? That only gets you to about 30 degrees Pro-Tools 105 Bender Die, 3/4 inch OD x 2 inch CLR, 180 degrees

I understand the tall pin is pushed on by the edge of the swing arm on the machine, but once you've reached full extension of the cylinder and go to reset, there's nothing to push on the pin for the next sweep. I assume there is a way to continue the bend since these are advertised as 180 degree dies.

Thanks!
Cedric

Status: Open Apr 30, 2024 - 01:25 PM

Do you have the same question? Follow this Question

1answer

Answer

Apr 30, 2024 - 01:25 PM

Small radius dies like this can only be bent hydraulically up to one stroke. See the note on this product **SRBA Adaptor recommended for all 2 and 2.5 inch CLR die sets (see Accessories tab).
This adaptor is not required but aids in using a manual bender handle or piece of rectangular tubing to bend up to 180 degrees with this die.

0

View More Product Details

How do you use these past one full extension of the hydraulic cylinder? That only gets you to about 30 degrees

Pro-Tools 105 Bender Die, 3/4 inch OD x 2 inch CLR, 180 degrees

This die fits the Pro-Tools Model MB-105 and MB-105HD Tube Benders and can be used to bend the specified size in mild steel, stainless steel, DOM, 4130 chrome moly and more. OD - refers to actual Outside Diameter of the tube as measured with a caliper. Minimum Wall - denotes the minimum recommended ... See More

View Details

View all Pro-Tools 105 Bender Die, 3/4 inch OD x 2 inch CLR, 180 degrees Questions & Answers

How do you use these past one full extension of the hydraulic cylinder? That only gets you to about 30 degrees Pro-Tools 105 Bender Die, 3/4 inch OD x 2 inch CLR, 180 degrees

1answer

Answer

View More Product Details

Related Product

Browse by Topic

Tools