need to notch 2 1/2" pipe with a 4" hole saw; do you know if a 4" hole saw will have clearance?
BuildPro Tube and Pipe Notcher
Status:
Open Jun 10, 2024 - 07:25 AM
1answer
Answer
Jun 10, 2024 - 07:25 AM
There are a few deep hole saws on the market but they are expensive. A typical hole saw notches slightly less than 2” depth so it would not go through your pipe all the way. With a 90 degree notch you can leave some flat on the end of the cut and only cut about 1/3 of the pipe and it will fit up fine. Most customers just break off the remaining with a pliers or use a cutoff wheel to complete the notch with this method.
View More Product Details
BuildPro Tube and Pipe Notcher
This notcher is ideal for attaching to a Buildpro table, Rhino cart, or any fixture table using 5/8 holes with 2 inch center to center spacing. The 1 inch diameter shaft is supported by needle bearings and can adjust up to 50 degrees for angled notches. An included threaded adjuster makes dialing in...
See More
View all BuildPro Tube and Pipe Notcher Questions & Answers
