Answer
Apr 22, 2026 - 05:19 PM
Yes as long as the bend is in the horizontal plane when clamped, there is some ability with this notcher. The most flexible hole saw notcher for bent tubing is the Baileigh TN-250 due to its radial clamp design.
Can you clamp a tube with a bend on this notcher? 1.125 tubing, 75 deg bend, notch at start of the bend. BuildPro Tube and Pipe Notcher
Notch is perpendicular to bend so tubing would clamp flat to the surface.
Status:
Open Apr 22, 2026 - 05:19 PM
Do you have the same question? Follow this Question
1answer
View More Product Details
BuildPro Tube and Pipe Notcher
This notcher is ideal for attaching to a Buildpro table, Rhino cart, or any fixture table using 5/8 holes with 2 inch center to center spacing. The 1 inch diameter shaft is supported by needle bearings and can adjust up to 50 degrees for angled notches. An included threaded adjuster makes dialing in...
See More
View Details
