I just bought a fixture table with 5/8 holes. The thickness is 1/4, which one would right for me to get? View answer
Asked 2 ´years ago | BuildPro Ball Lock Bolt, adjustable two-position, 12 pack
can this unit be used as a hole punch? using 11 gauge stainless with 3/8" hole. View answer
Asked 2 ´years ago | Mittler Bros. Hydraulic Bench Press, 5 ton
Can you tell me the amp draw of this particular saw? View answer
Asked 2 ´years ago | Roll-In JM1220 Vertical Band Saw
I already purchased the table-mount/vise combo. So, is it possible to purchase the wall-mount by itself? View answer
Asked 2 ´years ago | Versa-Mount Vise and Grinder Wall Mount
Nominal pipe capacity is 2" sch 40 but will it do this with Stainless pipe as opposed to Steel pipe? View answer
Answer updated 2 years ago | Baileigh RDB-250 Programmable Tubing Bender Deluxe Kit
how many tons are needed to notch stainless steel pipe 1 1/2" schedule 40 using this notcher? View answer
Asked 2 ´years ago | Pipe Notcher Housing for up to 2-1/2 inch OD Tooling
Voltage View answer
Asked 2 ´years ago | Scotchman 5014-ET, 50 ton Ironworker
Can a bend of 180 degrees be made with a radius brake for a driveshaft tunnel ? And all 5 radius bars? View answer
Asked 2 ´years ago | MetalAce 6 foot Radius Brake with 5 Radius Rolls, 16 gauge
What is the voltage of this? View answer
Asked 2 ´years ago | Grit GXC Centerless Grinding Attachment for GX75 Grinder
What type of brake would i use to bend 14 gauge aluminum and 16 gauge steel? View answer
Asked 2 ´years ago | Betenbender 10 foot Press Brake, 50 ton