This does saddle pipe on to pipe? IE. 1-1/2" ON 1"-1/2" 90 DEG. Will it do 1" on 2"? View answer
Asked 4 ´years ago | Grit GXR Pipe Notching Module for Grit GX75 Grinder
would this be the correct die for 3/8x 1" flat bar.? how tight of a diameter can I roll? View answer
Asked 4 ´years ago | Hulk Bender Rolls, Up to 3 inch Wide Flat Stock, Easy Way
what is the MINIMUM clamping size please? thank you View answer
Asked 4 ´years ago | Round Stock Pliers
Can you bend/roll aluminum tube with this machine? View answer
Asked 4 ´years ago | Swag Off Road Hulk Manual Roll Bender
Can this be used to put 6mm hole in 1/4" 316 Stainless with a handheld drill? View answer
Asked 5 ´years ago | Flowdrill Starter Kit - Metric
Will this cut aluminum coil trim adequately? View answer
Asked 4 ´years ago | Roper Whitney No. 541 Hand Notcher, 90 degrees
If i buy the 2 6” riser i need to attach a plate from the table on the side what other hardware would i need View answer
Asked 2 ´years ago | BuildPro 6 x 2 x 2 inch Riser Block with 4 Surfaces
Is this planishing hammer compatible with CP style tooling? View answer
Asked 1 ´year ago | ProLine Hand-Held Tubular Planishing Hammer 180-90
What is the main difference between the tennsmith heavy duty and the regular style national brake View answer
Asked 2 ´years ago | Tennsmith 6 foot Heavy Duty Box & Pan Brake, 12 gauge
what is the max height of the jack required View answer
Asked 5 ´years ago | Bend Press Benchtop Press Brake, 20 ton
