Good morning, I was wondering, are you out of stock on this product CH-14? (Strong Hand Handi-Hammer 14 oz View answer
Asked 9 ´months ago | Strong Hand Handi-Hammer, 14 oz
Hole diameters? View answer
Asked 9 ´months ago | BuildPro 8 inch Riser Block, Econo Version
I have a RMD M325 Pipe bender, will this die work on my machine? View answer
Asked 9 ´months ago | Baileigh Bender Die, 1 inch SQUARE x 3 inch CLR, 180 degrees
Can i bevel plate steel 1/2" thick to a 45° angle safely without fear of the shaft snapping? View answer
Answer updated 9 months ago | Metal Beveling Router Bit, 45 Degree
Do you have a jig that allows you to drill on slight angle (instead of 90) for adding stainless steel cable stair? View answer
Asked 9 ´months ago | Drill-Rite Precision Drill Guide
i have a ellis 3000 band saw, is this wheel for either front or rear? View answer
Asked 9 ´months ago | Idle Wheel for Ellis Bandsaws, 12 inch
Do you have a clamp that works on 1-1/2" OD pipe? View answer
Asked 9 ´months ago | Icengineworks 1-7/8 inch Header Tack Welding Clamp
Is there a method to secure the table at a certain height (Safety Bar)? View answer
Asked 9 ´months ago | Siegmund Imperial 16 Mobile Lifting Weld Table, 36 x 48 inch
Specs tab indicates 14" blade but "includes" tab shows 12.5" Which is it? View answer
Asked 9 ´months ago | Scotchman CPO 350 Manual Cold Saw
WILL THIS FIT IN THE SCOTCHMAN cm 50 ironworker ? View answer
Asked 9 ´months ago | 13/16 x 1-1/2 inch Oversize Oblong Punch and Die for Piranha Ironworkers
