Does it for piranha p-50? View answer
Asked 1 ´year ago | 11/16 x 1-1/4 inch Oversize Oblong Punch and Die for Piranha Ironworkers
Will this set work with Edwards 25 ton press? View answer
Asked 1 ´year ago | Round Punch and Die Starter Kit for Edwards Ironworkers
What is the drive wheel dia. (to calculate SFPM) and what is the maximum safe RPM (I will be using with a VFD)? View answer
Asked 1 ´year ago | Multitool 2 x 48 inch Belt Grinder Attachment
2" SS tube is .065" wall so 2 " tube ID is 1.87" or 1 7/8" so I would need the 1 7/8" system? View answer
Asked 1 ´year ago | Icengineworks 1-7/8 inch Header Full Fabrication System
can use the on a Pextco 622. Then use the 22mm dies correct? View answer
Asked 1 ´year ago | 22mm Adapter Set for Covell Round-Over Dies
How many are there in a order? Just one single or how many? View answer
Asked 1 ´year ago | ALPHA28 Inserta Clamp, Screw Action
Hi. Do you have this set that will fit Ben pearson MC 59 ? View answer
Asked 1 ´year ago | Huth Bender Die Set, 1 inch Square x 3 inch CLR
what is the length of this bolt? View answer
Asked 1 ´year ago | BuildPro 16mm Ball Lock Bolt, 6 pack
What is the minimum wall thickness for bending 1.5" stainless steel tube? View answer
Asked 1 ´year ago | Ercolina SB48-TC Super Bender Tubing Bender
Which hammer/hammers should be a good start for forming 18 gauge steel such as a transmission tunnel? View answer
Asked 1 ´year ago | Bossing Mallet - Set of 3