Can i bevel plate steel 1/2" thick to a 45° angle safely without fear of the shaft snapping? View answer
Answer updated 1 month ago | Metal Beveling Router Bit, 45 Degree
Do you have a jig that allows you to drill on slight angle (instead of 90) for adding stainless steel cable stair? View answer
Asked 1 ´month ago | Drill-Rite Precision Drill Guide
i have a ellis 3000 band saw, is this wheel for either front or rear? View answer
Asked 1 ´month ago | Idle Wheel for Ellis Bandsaws, 12 inch
Do you have a clamp that works on 1-1/2" OD pipe? View answer
Asked 1 ´month ago | Icengineworks 1-7/8 inch Header Tack Welding Clamp
Is there a method to secure the table at a certain height (Safety Bar)? View answer
Asked 1 ´month ago | Siegmund Imperial 16 Mobile Lifting Weld Table, 36 x 48 inch
Specs tab indicates 14" blade but "includes" tab shows 12.5" Which is it? View answer
Asked 1 ´month ago | Scotchman CPO 350 Manual Cold Saw
WILL THIS FIT IN THE SCOTCHMAN cm 50 ironworker ? View answer
Asked 1 ´month ago | 13/16 x 1-1/2 inch Oversize Oblong Punch and Die for Piranha Ironworkers
would a 20ton press be enough to notch 1-1/2" sch 40? View answer
Asked 1 ´month ago | Pipe Notcher Housing for up to 2-1/2 inch OD Tooling
Hi, does this stand accommodate the Fein Slugger 14” chop saw? View answer
Asked 1 ´month ago | Evolution Universal Chop Saw Stand
is this able to be on a 230 or 480 v power drop, or would you need a transformer? View answer
Asked 2 ´months ago | Roll-In JM1220 Vertical Band Saw
